VGA延长线制作及故障解决(国外英语资料).docVIP

VGA延长线制作及故障解决(国外英语资料) How to make VGA on the network line to display the extension cord of 2012-02-02-08 12:04:54 | classification: hardware DIY | label: | for large and small subscriptions. The network line makes VGA display extension cord VGA pin definition and welding method 15 needle VGA definition: 1PIN - red for analog signals 2PIN - the green of the analog signal 3PIN - the blue of the analog signal 4PIN - address code 5 pin - N/C 6PIN -- simulate the ground end of red 7PIN -- simulate the green ground end 8PIN - simulate the blue ground end 9 pin - spare 10PIN -- the digital grounding end 11 pin - address code 12 pin - address code 13PIN -- the line signal 14PIN - a vertical line signal 15PIN - ground (shield) Transformation of VGA line: two VGA plug (RMB 2.5 * 2) using wire line (RMB 2.0 / meter). The VGA line is welded with eight lines, and the display is a liquid crystal with an LCD 17 inch refresh on 1280 * 1024 60Hz, which is normal. Why use the wire? Because the VGA line is too big (the wall requires a lot of holes), the price is not cheap, the line is hard, the wiring is not beautiful. The network line can drill a common 8mm hole on the wall, buy white line basically and the wall one color does not affect beautiful. The 8 core wire of the network wire welding VGA needle welding method: 35W soldering iron, rosin, solder wire 1, 2 and 3 feet are used for each of the two colors. Article 3. 5, 6, 7, 8, 9, 10 feet use 2 of the colors and weld them together to make a public place. Article l2. L 4, 11, 12 The line of one of the colors in the net. Article 1. The line of one of the colors in the net. Article 1. The line of one of the thread in the net line and the welding of the VGA plug. Article 1. The screen layer is also wrapped in the VGA plug case, and the plug of the plug in the plug is not easy to bend and damage. See you have a lot of questions, in fact as long as it is easy to learn electrical or electronic to make all, what signal attenuation opinio