世光测光表使用说明(国外英语资料).docVIP

世光测光表使用说明(国外英语资料) A first. The SEKONIC light 508 meter USES the manual One. Part name (1) (2). The diffuse ball (3). The LCD (4).average/EV value buttons (5). Setting/converting the dial (6). ISO2 button (7). The switch (8).sync line (9) (10). Mode setting button (11). ISO button (12). The enhancer interface (13). Memory clearing button (14).memory button (15). Zoom lens protector (16). 1 ° ~ 4 ° zoom ring (17). The incident/reflection switch (18). Viewfinder eyepiece (19). Light buttons (20). Battery cap (21). Battery cover (22). DIP switch (23). Battery storage (24). Zoom lens cover (25) (26). The straps Two, about LCD display Automatically light When using the environment dark (EV3 or below this value) blue backlight automatically illuminating the LCD screen, when using option micro receiver and enhancer, LCD on at total after metering, regardless of the level of light and dark. At the same time, the LCD does not light and the LCD does not glow when using the sync line. The light lasts for 10 seconds automatically. (1). Test the schema icon Field light (see page 8) Flash (no attachment) (see page 15) Flash (using attachment) (see page 13) (2). The incident reflection icon (see page 6) The incident Reflection spot metering (3). ISO show Display film ISO setting When ISO 2 is pressed, the second ISO setting is displayed (4). Exposure compensation instructions When setting up the exposure compensation, it will be displayed. (5). Aperture priority, aperture priority, EV difference, mean and EV display Is in aperture priority (see page 10) Indicates the state of the test light ratio (see page 20) Means to be on average (see page 19) Indicates the state of the EV value (see page 11) (6). Aperture values analog display and memory simulation display Display aperture values, average, and memory data. Its lower than the range of light It is higher than the range of light (7). The shutter priority indicator, the shutter speed display, and the frame/second display during fil