单点接地和 多点接地详解(国外英语资料).docVIP

单点接地和 多点接地详解(国外英语资料) Single point earthing multiple ground The problem with single points is the common ground impedance coupling and low-frequency ground loop. Multi-point is aimed at the common mode interference that the high frequency is easily generated by the long line. The working frequency of low frequency circuit, the signal is less than 1 MHZ, little impact on its inductance between wiring and devices, and grounding circuit had a greater influence on the formation of the circulation of interference, thus should use one-point earthing. When the frequency of the signal is greater than 10MHz, the ground line impedance becomes large, and the ground line impedance should be minimized at this time, and the ground should be more ground. When the working frequency is 1 ~ 10MHz, if a bit of ground is adopted, the length of the ground should not exceed 1/20 of the wavelength. Digital ground is ground between the analog ground, the number is multipoint. Ground line interference and ground line design The ground line design is an electromagnetic compatible design that everyone notices, but doesnt know how to do it. After understanding the mechanism of the interference problem caused by the earth line, a definite train of thought was established in the design and implementation of the geodesic. This paper starts by introducing the principle of interference from the ground line, so that the reader can understand the key and the principle of designing ground line. What is geodesic? The ground line is both safe and signal. The former is a geodesic to ensure safety and safety of the equipment, which is designed to ensure the correct work of the circuit. The main thing that causes circuit interference is the signal, so this is just a matter of signal. The general definition of signal ground is: the potential reference point of the circuit. More properly, this definition is a hypothesis when we design the circuit. From this definition there is no analysis and understanding of