开机问题(国外英语资料).docVIP

开机问题(国外英语资料) A lot of people turn on, no response, then panic, you dont defend to see this article, to your club help s flat I summarize the reason is that there are a lot of people have put forward a similar problem, actually is not a big problem, you just know some common sense. You try. BIOS self-check and start fault processing What is an electric self-check on POST? POST electric self-check: the routine procedure of a self-check in the system after the microcomputer is connected to the power supply. This process is often called POST - Power On Self Test. Nearly all the hardware of the system is tested. How does POST do self-testing? When the motherboard is plugged in, the system is first checked by the Power On Self Test program. When we press the start button (power switch), the control of the system by the BIOS to complete, because the voltage is not stable, control mainboard chipset will sent CPU and maintain a RESET (RESET) signal, let the CPU initialization, at the same time wait for POWERGOOD signal from the power supply (power supply ready signal). After the stable power supply to the power supply (from stable to stable, of course, the process is only a short moment), chipset and removed the RESET signal (if it is a manual press the RESET button to restart the computer panel machine, then release the button and chipset will removed RESET signal), CPU will soon begin to execute instructions from address FFFF0H, within the scope of this address in the system BIOS, whether Award BIOS or AMI BIOS, here is a jump instruction, to real startup code in the system BIOS. System BIOS startup code first thing to do is to POST (Power On Self Test, plus electricity self-inspection), as a result of the computer hardware equipment many (including memory, interrupt, expansion card), so to Test the equipment working condition is normal. This process is carried out one by one, the BIOS vendors for each device is given a test CODE (called a POST CODE or POST CODE), in a set