异步启动(国外英语资料).docVIP

异步启动(国外英语资料) For cage asynchronous motors Start directly: starting current is large, causing the motor to overheat Stator series resistance, or reactance, start Auto-transformer decompression start Star - triangle decompression start The 2.3.4 start method can reduce the start current, but the start torque will also decrease The asynchronous motor has a squirrel-cage and winding type. For larger capacity of the squirrel-cage motor, if take direct start, can make the power grid voltage fluctuation seriously, so take the star delta step-down start, a third of the starting current for direct start, so a third of the start torque as well as direct start, so the start is suitable for light load or light load start. Large capacity winding asynchronous motors are usually activated Wound rotor asynchronous motor with squirrel cage asynchronous motor is the main difference between the wound rotor asynchronous motor rotor three-phase symmetric winding, start usually adopts the rotor resistance when start, or it is frequency-sensitive rheostat starting. The rotor string resistance of the wound rotor asynchronous motor is started Starts, the string in the wound rotor asynchronous motor rotor loop into the appropriate three-phase symmetric resistance, if the correct selection of resistor resistance, make the rotor circuit of the maximum torque generated in the motor start instantly, so as to shorten the start-up time, achieve the goal of starting torque increase with the decrease of starting current. The variable resistance decreases with the speed of the motor. After start-up, the variable resistance is reduced to zero, the rotor winding is short, and the motor is running at the rated state. The advantage of this boot method is not only can reduce the starting current, and can keep the starting torque is bigger range, in need of overloading starting equipment such as bridge crane, hoist widely adopted, gantry crane and other occasions. The disadvantage is that the required boot