手机电流法(国外英语资料).docVIP

手机电流法(国外英语资料) Typically, the current is 20 -- 30 -- 120 or 180 CPU (50ma) - software (60-100ma) - search network (200ma) - standby (10-20ma jump) The average cell phone starts at 50 to 150 ma, and the current is 150 to 250ma, with a standby current of 10 to 15ma. MTK turn on current 0mA - 20mA - 50mA - 40mA - 100mA Without a card, the normal current of the receiver is 0mA (low), 50mA (middle), 180mA (high), 140mA (center), and the light extinguishing 20mA. If 140mA does not shake, the lamp goes to zero, the phone does not receive The order in which the phone works is the power, the clock, the logic, the reset, the reception, the launch 7. Under normal circumstances, and the key - background lights first - to rise to about 50 ma work the power supply has begun -- and then rose to about 100 ma show that electrical road work RX - rose to 200 to 250 ma RX and TX have job and looking for network - and then back to about 150 ma, find a network, which have not been in standby mode, but the background light is bright, and then put out, current back to 10 to 15 ma, back and forth to specific standby, the current changes can be observed, that mobile phone work normally There is no current reaction to the power switch A: it is important to check that the wiring is broken. B. Replace 32.768 KHZ crystals. C. replant or replace IC. The charge is about 5MA on the boot A. check the VRTC real-time clock power, if not for most power IC damage. B. replant or replace cpus. Turn on the current only a few milliampere, loosen the hand return zero, general is the clock circuit has a problem, common is 26MHZ crystal false weld or damage! There is a 10mA current for the 13M main clock problem: start with 13M (or 26M) power, and the AFC control voltage (usually about 1.5 vs) The power supply and the AFC normal replacement of the 13M circuit should ensure that the 332.768 KHz real-time clock and logic circuit are normal Press the boot key, turn on the current only only 10-30ma, the hand