无线话筒断频跑频处理简方发(国外英语资料).docVIP

无线话筒断频跑频处理简方发(国外英语资料) The wireless microphone breaks down frequency to handle the short hair 1, in wireless microphone 9 V battery negative terminal by using enameled wire spiral wound as secrets, fixed plate opposite the tongue, and at the end of the wireless microphone V segment is longer (around 2.5 MM in diameter round round again return to the starting point), U for short (around 4 MM in diameter round squash) 2, just put the 9 v battery anode shell connected with the battery, make wireless microphone transmitting antenna through the battery shell, can increase the firing distance, prevent Duan Pin, running frequency Have the ability to remove wireless microphone. . Take out the tail more than 2 inches, revealing more than half an inch of circuit boards, find tube position, at 1 P capacitance (or a few P capacitance and the minimum capacitance) in welding use enameled wire spiral wound as secrets, fixed groove at the end of the wireless microphone, screw diameter less than about groove width, flattening fixed in the groove note: using 5 wireless microphone dont adapt to this party, by using 5 wireless microphone has been using the battery shell of the battery 4, if the frequency segment is wrong. Please open the string frequency receiver cover, will be in the lead-in from inductance and weeks, etc., and high on the top or near the side walk, prevent the antenna signal directly series inductance and the week, etc. (the second tuning). There may be some effect, but try it It is not useful to use multiple radio frequencies in the same place. Two of them produce a third frequency, just like two rocks in a river, and two waves of interference produce a third wave. Due to two waves of similar frequency, the third wave is similar to him, and the third wave will interfere with their uncles and aunts. Generally, the factory will avoid this situation in advance, but it will not be avoided. So its also a practice to understand that these frequencies are the ones that can