爱普生R210故障解决大全(国外英语资料).doc

爱普生R210故障解决大全(国外英语资料) Epson R210 failed to solve the problem The lights went on to the 2007-8-26 My 230 two lights flash, no place would be in, put a few days later after cleaning, normal. Not a few days is two and two lights flash, put a few days, the ink vehicle place. Can be printed, paper hooks in place after automatically exit, and then two lights flash. Expert advice please. Grateful. View (35) comments (1) Common problems and solutions for Epson Epsons R210 / R230 printer are 2007-8-21 Currently EPSONR210, 230 machines sell more. The customer is doing well too. The machine is highly accurate and fast. But there are several problems EPSONR210, 230 of the paper problems: There is a problem with playing card paper. The problem of inferior inkjet paper is even bigger. Because the paper of the printer is basically coating, the coating process of cheap card paper and inkjet paper is very bad! The user can wipe with the finger, the coating powder fall down, this is the reason that causes the paper to be slippery! So the user is using R210 and 230 to make the paper more than a few months for the paper. Photo paper can be used to get rich, ink jet paper to choose the prince to get 2000. The quality of the card paper is good. I only recommend useful materials to my friends. Special instructions for the first installation of a connected customer please note! A. using EPSON210, the most important question for the ink system in continuous supply is that the outer cartridge must be in the same horizontal plane of the printer! (putting a foreign box in a higher position than a printer results in ink leaking to the print head, which is a serious mistake!!) Be sure to open the vents and put on a filter, which is the easiest way for first-time customers to forget to operate! C. When fixing the pipe, be careful to center the line. This way the line will swing back and forth with the minimum amount of work to keep the line down within the minimum range! On EPSON210, 230 has just