理想GR机型(国外英语资料).docVIP

理想GR机型(国外英语资料) Ideal GR type The T1 / E01 main motor locks, displays and interrupts the machine (1) after the main motor starts 2 seconds after the main motor starts The sensor can still detect cylinder position A (2) within 5 seconds of the main motor starting, position A sensor Failed to detect cylinder position A press full recovery key The T2 / E02 motor locks, shows and interrupts the machine operation (1) the action block of the lifting devices upper limit sensor is not raised within nine seconds of the start of the lift motor (2) the light path of the lower limit sensor is not in place within nine seconds of the starting and lowering of the elevator motor 2 seconds after lifter start up, the light path of the lower end sensor is still in place (4) after two seconds after the start of the elevator motor, the motion block of the lower part of the device still lifts the full recovery key The T3 / E03 first class folder fault, shows and interrupts the machine running (1) the coil is activated in 4 seconds. The action block of the safety switch is still under pressure (2) in 4 seconds after the release of the clip coil (off), The action block of the safety switch is not pressed down (3) the Angle is within 8 seconds of the turning of the machine The degree sensor (0 and 180) failed to detect the Angle magnet (4) when the coil is not operated, the clip is in The action block of the safe switch is not pressed down to press the full recovery key T4 / E04 ink spills, shows and interrupts the machine running if the overflow sensor is detected in the extrusion unit Multiple ink spill sensors are turned off The T5 / E05 printing position motor locks, shows and interrupts the machine running in the printed position machine and the machine begins to rotate to 12 Second, if the state of the sensor in the center of the vertical is not connected to the full recovery button (or break through) The t6/e06 pressure test sensor failed to show and interrupt the machine running afte