网卡命令(国外英语资料).docVIP

网卡命令(国外英语资料) AIX network card in the system view and configuration command source: what new style Click: 647 times the 647 [yi gen Cms: to make the site more simple] [reading] AIX network card in the system view and configuration commands In AIX, the network card is used to represent the beginning of ent, a network card in the system, in fact, you can see two device interface, en is the beginning of the Ethernet standard II, et is the beginning of the IEEE 802.3 standard. There are two standards for Ethernet frames: Ethernet II (or Standard Ethernet) and IEEE802.3, which are primarily upper level protocols for flag frames Check and configure commands for network CARDS on the AIX system In AIX, the network card is used to represent the beginning of ent, a network card in the system, in fact, you can see two device interface, en is the beginning of the Ethernet standard II, et is the beginning of the IEEE 802.3 standard. Ethernet frame has two standards: Ethernet II (or called Standard Ethernet) and IEEE802.3, the difference is main sign frame mode of upper protocol, Ethernet USES the value of a TYPE II, said while using a data LENGTH IEEE802.3 said. In general, Ethernnet II is more commonly used, and we normally configure IP addresses on the enx interface. For example: # lsdev - Cc if The en0 Available 2008-08 Standard Ethernet Network Interface The en1 Defined 8-09 Standard Ethernet Network Interface The en2 Defined 0a-08 Standard Ethernet Network Interface The en3 Defined 0a-09 Standard Ethernet Network Interface Et0 Defined 2008-08 IEEE 802.3 Ethernet Network Interface Et1 Defined the IEEE 802.3 Ethernet Network Interface Et2 Defined 0a-08 IEEE 802.3 Ethernet Network Interface The et3 Defined 0a-09 IEEE 802.3 Ethernet Network Interface The lo0 Available Loopback Network Interface Lo0 represents the local loop interface, which is 127.0.0.1 View the specific properties of a network card # lsattr - El ent1 View the properties of a network card device interface # lsa