网线中的超5类线和6类线有什么区别(国外英语资料).docVIP

网线中的超5类线和6类线有什么区别(国外英语资料) What is the difference between the super5 lines in the network and 6 lines? Class line mainly for 100 m network is put forward, and, of course, to 10 m network is more than enough, the way it works is basically half duplex mode, five types of line standard is the most mature, also is the mainstream in todays market. Later, when developing gigabit Ethernet, it was intended to run on five classes of double stranded wires. But in practice it has been found that the existing five types of cabling products in support gigabit network application may have about 30% pass the electrical performance test, the information that is not all the five types of cables can be run gigabit Ethernet, mainly reflected in the electrical performance whether meet the gigabit Ethernet required 4 full duplex transmission of core requirements, namely from full duplex transmission of information, in with four core cable, each pair of cables and cable on different combination, such as its NEXT indicators shall conform to the stipulations of the five types of cable specification, each pair of lines is supported by 100 MHZ bandwidth, 4 to the core with a 400 MHZ bandwidth available, the design of gigabit Ethernet operation frequency is 400 MHZ. The double stranded wires that meet the existing five standards require two pairs of wires with a width of 100MHz. As a result, many manufacturers can run five gigabit Ethernet products labeled as Enhanced (Enhanced Cat 5, 5 E) into the market, the United States of TIA/EIA 568 - a - 5 is 5 E standard, five E also known as super five types, this is the origin of 5 E. The next six categories, super6, and even more recently, have been raised in seven categories, primarily in relation to the development of the computer network. According to Moores law, the information needs of computer network can doubles every 18 months, the emergence of the computer network development to a one billion - bit Ethernet, the integrated wiring system pu