监理员培训(外国英文资料).docVIP

监理员培训(国外英文资料) To check the division, division, division, unit engineering division and acceptance The concept of batch, branch, branch and unit engineering Inspection batch: to be collected in accordance with the same production conditions or in accordance with the prescribed manner, the inspection body consisting of a certain number of samples. Partial engineering: a basic unit project consisting of one or several inspection batches Division project: refers to the division of the unit project into a number of parts in the professional or construction parts, each part of the project Unit engineering: in the construction project, which has an independent design files, can play an independent production capacity after the completion of engineering or engineering benefit, and can constitute a part of the construction project Check the approval of batch, branch, branch and unit project Batch of inspection: The inspection batch is the minimum unit of project acceptance, which is the basis for the quality acceptance of the project and the construction project. There are two aspects to verifying the qualified quality of the batch: data inspection, master project inspection and general project inspection. Quality control data reflects the inspection batch from raw material to final acceptance of the construction process of operation, necessary to check the situation and ensure the quality management system, etc. The inspection of its integrity is actually a confirmation of process control, which is a prerequisite for verifying the approval of the batch. The qualified quality of the inspection batch shall depend on the test result of the main control project and the general project. The main control project is a test project that determines the fundamental quality of the inspection batch, and therefore must comply with the relevant regulations of the relevant professional engineering. This means that the master program does not allow for the test results that do not meet the