AutoCAD中调整线条宽度的实用工具(国外英文资料).doc

AutoCAD中调整线条宽度的实用工具(国外英文资料) Utility for adjusting line widths in AutoCAD Release date: 2010-4-6 [collection comments did not find the desired knowledge] In the use of AutoCAD graphics software to draw all kinds of graphics work. The last stage is to finally export the graphics file to the printer and plotter. The delineation of the lines of graphics is a task that must be taken seriously. Because the graphics on a general drawing do not have the color and depth of color to be used on a color display, it is only possible to change the thickness of the lines by changing the thickness of the lines. Therefore, dividing the line thickness in the graph is helpful for distinguishing the graphic elements, and also for the accurate expression of the design intention and the convenience of the mapping. In particular, engineering drawings should be in accordance with the national drawing standards, the map of the elements into a clear thickness. In this way, the drawings can meet the requirements of standardization. In fact, the thickness of the line varies from coarse to fine, and the width of the line is reflected in the computer graphics file. Common for example, graphic entities outside the corridor, graphic symbols and table frame line are thick lines, section lines, dimensions (circles), line symbol leads, center line, dotted lines should be thin, while the dotted line and between thick and thin lines between. And according to the requirements, coarse, medium and fine wire can also change linewidth in a certain range. Usually the designer or drawing use AutoCAD drawing software in the computer, often used to like COPY, OFFSET, MIRROR group command, to enhance rendering efficiency, and does not consider too coarse linear line photos, but this issue will be put out in the drawing copy only with the adjustment solution. Because at this time, Tusudo, such as by interactive commands to adjust, very complex and time-consuming, other methods are difficult to solve the problem s