CAD绘图与打印比例控制、套用图框、标注命令(国外英文资料).docVIP

CAD绘图与打印比例控制、套用图框、标注命令(国外英文资料) The drawing is completed, we will print out drawings, only when the drawings printed (white figure or sulphuric acid paper blueprint) can, we think the basic drawing finished (of course, filing etc.). When printing, there is a ring can not be avoided, that is the question of proportion. The printing proportion and drawing proportion are reasonable, then the finished drawings are clear, beautiful and beautiful. We often see some drawings densely packed, and some drawings empty, these are the proportion of improper control. So what should we pay attention to when drawing and drawing at the time of printing proportion and drawing proportion? In general, we eventually print the drawings in proportion to and not in proportion to the two. In accordance with the proportion of the general construction plan; not in accordance with the proportion of the situation there are many, there are program text, graph (yourself), condition diagram, preliminary design in recent years (preliminary design) has gradually become a A3 text size in accordance with the proportion of printing. Take a look at the construction drawings printed in proportion. Construction drawings are basically shown in proportion, but there will be different scale settings in the drawing. For example, Ping Li profile is usually 1:100, staircases, the bathroom is 1:50, 1:20 is a large sample node, nodes in a large renovation plans in may have 1:10, 1:5, 1:2 ratio, 1:500 ratio is commonly used in general, sometimes there is 1:1000, 1:2000 etc.. I next to a flat vertical profile, staircases, toilet proof and details of conventional construction drawings to illustrate. First of all, we usually start with a plan, and then we should draw each of the 1 units of standard AUTOCAD in the actual 1MM, and the other vertical sections are the same. At this point, we have two places should pay attention to, first, all fonts should be set to about 350 height, room name can be slightly larger, draw