ubuntu_3D(国外英文资料).docVIP

ubuntu_3D(国外英文资料) First, make sure the video card driver is installed and enabled, and then install the following two software: * compizconfig-settings-manager (for 3D special effects) * emerald (set theme for use) Code: Sudo apt-get install compizconfig-settings-manager Sudo apt-get install Emerald Click on the -Advanced Desktop Effects system - preferences Settings open CompizConfig Settings Manager (CCSM) 1, 3D desktop settings: click on the General options, the Desktop Size tab in the Horizontal Virtual Size (virtual level size) is set to 4, Vertical Virtual Size (virtual vertical size) is set to 1, Number of Desktop (desktop number) is set to 4 (there are a lot of people mentioned in this forum a little to do, my experience is that a little and a little, the default is 1, without modification), back, check the Desktop Cube (desktop cube), Rotate Cube (rotating cube) and rotate Cube and Cube Caps items, press Ctrl+alt then press the left mouse button mobile, 3D desktop effects. (cube reflection, Cube, Caps) is not necessary, to increase the effect 2, the cube becomes transparent: the Cube Gears (cube gear) (in specific categories) in front of tick, and then click Desktop Cube, select Transparent (desktop cube) Cube, Opacity During Rotation will be reduced to about 50, then the 3D desktop tune out the cube into a semi transparent, and there are three in the rolling gear! 3, adjust the cube size: click on the Rotate Cube (rotating cube) (in desktop category) - , Zoom (zoom) adjusted to 1, the Speed (speed adjustment) to 0.7, and then press Ctrl+alt+ to the left / right arrow key, you can see the cube when moving in slow motion, and a lot of small cubes. 4, automatic open window arrangement to the screen: check the Scale (in the window management category) - buttons Bindings click Initiate Window Picker For All Window on the right side of the project, use the mouse to click on the pop-up window in the lower left corner, then OK button to Bottom Left. Move the mo