不锈钢压接管技术指导(国外英文资料).docVIP

不锈钢压接管技术指导(国外英文资料) Stainless steel clamping pipe fittings and stainless steel pipe installation technical disclosure book In order to make the stainless steel pipe in the installation and use in order to ensure the safety and quality of the use of stainless steel In the construction of pipelines, the technical performance, characteristics and installation methods of stainless steel pipes will be necessary before construction The technical supervisor of the construction party and the operator shall make technical clarification and sign the document for future reference. The technical disclosure is in the cecs153:2003 building water supply thin-walled stainless steel pipe pipe project technical regulations. On the basis of it, the induction and summary are summarized, and the key points in the operation are emphasized. Where technical disclosure book Not involved in the content, all according to cecs153:2003 building water supply stainless steel pipe pipe project technical regulations to implement. Installation operation points First, broken pipe First, pipe cutter tube in accordance with the construction size cut, with a special stainless steel file or angle grinder to remove cut Cutting surface burr, cut the pipe should make the pipe cutting surface and the pipe central line vertical, pipe end and appearance should be smooth and smooth Clean and oil-free. Two, connection preparation Mark the end of the end of the tube with a special scribe for a week to confirm the length of the pipe and the length of its insertion The reference values are shown in the following table: Nominal DN: insertion length of the basic value (mm): card pressure (MPA) Note: 152135-40 202440-45 252445-50 323945-50 403745-50 505250-55 655335-55 the first pressure is 35; Second times the pressure reaches 45; Third times the pressure reaches 55; Turn 35 degrees each time. 806035-60 the first pressure is 35; Second times the pressure reaches 45; Third times the pressure reaches 60; Turn 35 degree