小家电设计控制程序(国外英文资料).docVIP

小家电设计控制程序(国外英文资料) In this paper, we should study hard and contribute to the community DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. XXX Electrical Appliance Company Limited Design control procedure LQ/QP007-2009 1, the purpose of ensuring product design in line with customer and regulatory requirements, from the source to control product quality, 2, scope applies to the companys products from design approval to design, output, the whole process of management. 3, terms and definitions: hand hand prototype is the company after the completion of the design drawings, product in the mold through (not through mass production means) case, through other processing methods, made to reflect the prototype design intent. 4, process Responsible unit, Ministry of foreign trade, technology department, Ministry of foreign trade, general manager of Technology Department Flow chart Market Research Relevant regulations 5.1 Records and forms market demand analysis report Development suggestion NG Five point two New product development proposal, LQ/QP007-01 Feasibility evaluation, OK, design, plan Five point three New product development proposal, LQ/QP007-01 Technology Department Five point four New product development plan, LQ/QP007-02 Technology Department Exterior drawing design NG Five point five Three / 2D modeling drawing Technology Department Drawing audit Five point six Three / 2D modeling drawing OK Technology Department, Ministry of foreign trade, technology department, technical department, model making, NG 5.7 Exterior verification OK structural design Five point eight Three / 2D modeling drawing 5.9 NG Drawings Technology Department Drawings review, OK, turn 5.11 Five point one zero Drawings More free data downloads, please come in: Study the community well Design control program LQ/QP007-2009 Responsibility units, technology department, manufacturing department, qual