手动档聚散器任务道理与“半联动”应用技能(国外英文资料).docVIP

手动档离合器工作原理与“半联动”使用技巧(国外英文资料) These are semi linkage skills, not good performance. When the car started, transmission shaft two is still, when we need to hang a block, clutch, a shaft of the gearbox and power separately, by hanging a synchronizer gear, a shaft also becomes stationary. The power from the flywheel out there is a certain speed, this time with a shaft has great speed difference, which is why the start for half linkage requirements than the main reason when the shift is much higher, and part of the clutch of a stationary one motion. This speed difference must be half linkage to digest, is also the beginning of the power delivered to a shaft, can make the vehicle to start a steady attitude, once the vehicle, the speed difference becomes small, the clutch is completely lifted, there will be no impact. 2, has higher half linkage between digestion technique for semi linkage engine speed and wheel speed difference, that is to say there can be in power has been transferred to the wheel, but the wheel was not working circumstances, which often occur in the ramp. General for driving unskilled drivers, the ramp start will pull the handbrake, and then let the clutch in a semi state, release the brake and the stationary vehicle, anti slip car after car hit. The gravity of the vehicle going backward is opposed by the power provided by the engine, while the clutch is responsible for removing the difference in speed. Vehicles in this case, the driver will be able to easily start, and continue to step on the accelerator pedal to further improve the speed and get enough torque, the vehicle will rise smoothly. At this time for the semi linkage of higher skills, if half linkage strength is too weak, it may loosen the brake when the vehicle in sliding backwards, easy to cause the novice if half hybrid confound, strong, easy to spend is the vehicle to accelerate too fast and hit the front of the car. So for the novice, this can make the engine speed slightly higher, and the