渐开线花键计算(国外英文资料).docVIP

渐开线花键计算(国外英文资料)Calculation of 30 degree flat root splineModulus M = 3Tooth number Z = 15Standard pressure angle 1 D = 30 degreesCombination code: H7/h7Pitch diameter D = m * z = 45Base circle diameter Db = m * Z * cos (alpha D) = 38.9711P = pi = M = 9.42477796076937Internal spline, big diameter, Dei = m * (z+1.5) = 49.5Outside spline action, gear thickness deviation, ESV = 0(according to the mechanical transmission design manual, 1463, table 9-1-49, or calculated by the tolerance code)Maximum diameter of initial circle diameter of involute spline:DFemax = 2 x ((0.5Db) ^2+ (0.5Dsin (alpha, D) - (hs-0.5esv/tan (alpha, D)) /sin (alpha D)) ^2) ^0.5= 41.8669(where HS = 0.6m = 1.8)Inner spline path Dii = DFemax+2CF) = 42.47(where CF = 0.1M =.3)Internal spline, basic alveolus width, E = 0.5, PI M = 4xternal spline, basic tooth thickness, S = 0.5, PI M = 4nternal spline:Internal spline total tolerance T+ lambda = 40i*+160i** = 179Where i* = 0.45 (D) ^ (1/3) + 0.001D (D = (30 * 50) ^0.5 = 38.7298334620742)I** = 0.45 (E) ^ (1/3) + 0.001E (E = (3 * 6) ^0.5 = 4.24264068711928)Weekly cumulative tolerance Fp = 7.1 (L) ^0.5 + 18 =.078Where the circumference of the circle is half L = Pi mz/2 = 70.6858347057703Tooth shape tolerance FF = 6.3 psi F + 40 =.062The tolerance factor W F = m + 0.0125D = 3.48412291827593Tooth to tooth tolerance F, beta = 2 * (g) ^0.5 + 10 =.023Where the spline length is g = 40Synthesis tolerance = lambda = 0.6 ((Fp) ^2 + (FF) ^2 + (F beta) ^2) ^0.5 =.061Effect cogging width minimum = Evmin = 0.5 PI M = 4.712Actual cogging width maximum Emax = Evmin + (T+ lambda) = 4.891Actual cogging width minimum Emin = Evmin + lambda =4.773Maximum cogging width Evmax = Emax - lambda = 4.83External spline:Outer spline, big diameter, Dee = m * (Z + 1) = 48Outer spline path Die = m * (Z - 1.5) = 40.5Gross tolerance of external spline T+ lambda = 40i*+160i** = 179Where i* = 0.45 (D) ^ (1/3) + 0.001D (D = (30 * 50) ^0.5 = 38.7298334620742)I** = 0.45 (E) ^ (