聚氨酯泡沫(国外英文资料).doc

聚氨酯泡沫(国外英文资料) Just to generate foam than normal in foam inside and on the surface part without air bubbles or little bubbles, the epidermal layer to form a dense foam density is much higher in the internal surface of the foam in vitro, from the epidermis to the center of the core part of the existence of a density gradient ten obvious. In the soft polyurethane foam, it is a semi rigid molding foam developed for automotive steering wheel and handrail, as well as bicycle and motorcycle saddles. Along with the progress and products of raw materials, polyurethane soft foam processing technology of the professional business, the classification, according to the product function such as ordinary, soft foam, antistatic soft foam, lipophilic hydrophilic soft foam, soft foam, soft foam energy absorption and so on, these are the market segmentation and professional needs of the developed new varieties of foam, rapid development, classification is also very complicated. At present, the classification of polyurethane soft foams is still suitable for the traditional classification methods, that is, prepolymer method, semi prepolymer method and one-step method. Soft foam, high resilience foam, soft heat molded soft foam, cold molded soft foam, soft foam, antistatic soft foam, lipophilic hydrophilic soft foam, soft foam, soft foam energy absorption and so on, these are the market refinement and professional needs of the developed new varieties of foam, the rapid development. The classification is also very complicated. It is also a kind of view that the soft polyurethane foams are classified by the way of processing, that is, prepolymer, semi prepolymer and one-step method. [1] Polyurethane foam - use tips Notice the speed of the jet, usually as much as 2/3 of the required volume. Fill vertical upward gap should be filled; such as when the gap, because of the gravity, the uncured foam may fall, suggestions for proper support in just after filling, after curing of the foam and sea