最新四川企业管理培训师百强.doc

2014最新四川企业管理培训师百强 （前100强，排名不分先后） 李蔚先生：四川大学管理学院教授、博士导师、大势管理公司营销顾问 课程方向：市场营销、营销战略、金牌销售技巧、房地产营销规划 贺安波先生：四川大学企业咨询与教育学会会长、四川大学MBA职业导师 课程方向：干部管理能力、领导艺术、项目管理、执行力、国学与人格修炼 格桑泽仁壳牌石油四川大学政治学院教授，四川大学硕士生导师，四川省心理学会副理事长四川大学科技园新源人才培训中心客座教授NLP的核心理念 组织人际关系 亲子教育及感情家庭现任成都思维特咨询公司咨询培训师国家职业资格认证特聘教师。师企业团队成长企业团队问题诊断中高层员工甄选测评，政府机构与企业管理顾问四川省人民政府政务指南特邀顾问大向企业咨询公司总经理管理员工的职业心态高级培训师、北京时代光华资深讲师台湾著名实战企业经营管理专家中国科学院博士美国纽约州立大学访问学者商务礼仪 政务礼仪高效执行力管理 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the feeler gauge measurement of gauge blocks or finishing. bearing surface, markup should be in accordance with the mounting support pads, and retest the t