杨刚企业战略管理A卷.doc

题号 一 二 三 四 五 六 七 八 九 十 总分 得分 评卷教师 课程论文 请每位同学结合自己本学期所学企业战略管理基本知识及理论，选择食品制造行业某一个企业作为研究对象，认真收集相关资料，分析该企业的战略环境，认清企业优劣势以及企业面临的机遇及挑战，探讨该企业的发展战略或相关战略对策，写一篇不少于3000字的论文。 论文要求： 题目自拟。 论点符合理论与实际，有科学明确的结论。论据能紧紧围绕主题，选择的材料详实、典型、充分，论点与论据能相互结合、统一。 分析考虑问题全面，推理严密，数据准确可靠，分析准确。 能系统地运用理论与知识分析研究和解决问题。 表达论文结构严谨，层次分明，语言流畅，数字、图表、计量单位等用法规范。 篇幅3000字以上，试卷打印后手写，字迹工整，不得打印论文。     考 试 试 卷 开课单位：管理学院 考试课程：企业战略管理基础 考试学年、学期： 试卷编号： 2010-2011-2 试卷类型：A卷（开卷） 试卷页数： 5页 命题教师：杨刚 任课教师： 杨刚 学生姓名： 行政班： 座位号： 学 号： Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with n