JamesWalker油封介绍与应用剖析.ppt

* 5 Roughen the cut ends Using the coarse side of the abrasive stick, lightly abrade the cut faces of the seal to roughen them to produce a good key for the adhesive Care must be taken to avoid over-abrading the faces as this could result in rounding the edges or tearing the seal lip. 6 Clean cut faces and jig groove Wipe the cut faces with the impregnated cleaning cloth to remove dirt and grease, etc. Ensure no residual fibres from the cloth remain on the roughened surfaces. Wipe the silicone rubber aligning jig, paying particular attention to the groove where the seal profile will be seated. The success of this joining method is dependent upon the strength of the bond. Therefore it is of paramount importance to ensure that the seal surfaces are absolutely clean * 7 Slide jig onto seal Push the silicone rubber jig onto one end of the seal and slide it approximately 10mm beyond the cut face of the seal, leaving the seal face fully exposed. * 8 Brush on thin layer of adhesive Brush a thin layer of adhesive on both sides of one end of the nylon insert tab and reinsert this tab end in one end of the seal. Brush a THIN layer of adhesvie on both cut faces of the seal and on the remainder of the nylon insert tab James walker在冶金行业 与成套设备厂商项目配套服务： VAI， SMS， MORGAN， 中国一重，中国二重， 中冶京城，中冶赛迪，中冶南方，峡压重工 ****** 与终端客户的集成打包服务： 上海宝钢 唐山首钢系 武汉钢铁 莱芜钢铁 南京钢铁 有色铝铜 ****** Markets 其它行业应用 Aerospace Chemical petrochemical Defence Engineering Food beverage Hydroelectric Manufacturing Marine Mechanical process plant Metallurgical Mining quarrying Nuclear Oil gas Paper, pulp board Pharmaceutical Power generation supply Semiconductor electronics Telecommunications Transport Water waste Wind energy James Walker Sealing Products Services 全球项级密封产品制造商 JW Products Services　 Walkersele? OSJ主要元件 开口式油封 弹簧 尼龙插片 硅胶定位装置 温度显示条 浸渍过的布条 树胶胶及凝固剂 夹紧带 双面粘纸 Walkersele? OSJ元件 现场安装型开口密封（OSJ）安装步骤 1 安装前密封是松的 不要去削密封头 2 混和胶水 现场安装型开口密封（OSJ）安装步骤 将密封头朝外 将密封绕在轴上并确保密封的方向正确 现场安装型开口密