特种设备使用管理准则.doc.doc

前 言 本标准按GB/T 1.1-2000《标准化工作下列文件中的条款通过本标准的引用而成为本标准的条款。凡是注日期的引用文件，其随后所有的修改单（不包括勘误的内容）或修订版均不适用于本标准，然而，鼓励根据本标准达成协议的各方研究是否可使用这些文件的最新版本。凡是不注日期的引用文件，其最新版本适用于本标准。GB18218-2000 重大危险源辨识 GB/T?19000-2000(idtISO9000:2000)? 质量管理体系 基础和术语 GB/T28001-2001 职业健康安全管理体系 GB50160(1999年版)(2001年版)劳部发［1996］276号质技监局锅发[1999]154号TSG Z6001-2005 《压力容器安装改造维修许可规则》TSG R3001-2006 《关于更换特种设备安全检验合格标志的通知》质检锅函[2003]62号 《特种设备目录》国质检锅[2004]31号 《锅炉压力容器使用登记管理办法》国质检锅[ 2003]207号 《火力发电厂劳动定员标准》（试行）国家电力公司（1998） 《锅炉压力容器压力管道特种设备事故处理规定》（2001年9月17日中华人民共和国国家质量监督检验检疫总局令第2号））） DB3201/T —2007 DB3201/T —2007 the same direction of rotation 90 ° or 180 ° for; after each disc rotor when measuring position alignment of the two half coupling constant, should also be in terms of accuracy and consistency. Surface deviation measurement, must in every 180 degrees corresponding to the two radii are equal to each other in order to eliminate errors caused by movement of the rotor. Only a support bearing of the rotor, WA couplings, such as the use of temporary leave the Center, should pay attention to keep the rotor in the measuring process in the center of the bearing oil retaining the nest does not change. Steam oil block, there should be sufficient clearance between the rotor and, in rotors make sure rotor is not on the block or seal oil. At the time of measurement, connections are not allowed between two rotors, each in a free State. Not allowed in case of assembled sleeve, Center work on the toothed coupling. Coupling tool should have adequate stiffness, installation must be secure and reliable. Coupling Center using a dial indicator, the table should be put in prison and avoid touching, to ensure correct measurement. Coupling disc after a week to return to the original position, circumference of dial gauge reading should be able to go back to the original value. When measuring the clearance of end, into the feeler of the gap should not exceed four at a time, when the gap is too large, you can use the gasket with the