种简单好看的扎头发方法图解.doc.doc

30种简单好看的扎头发方法图解?你值得拥有 30种简单好看的扎头发方法图解 你值得拥有 30种简单好看的扎头发方法图解，包罗韩式编发、盘发、花苞头、蜈蚣辫等流行发型，赶快扮起来吧！（图片有点多 打开会比较慢。。。） 1、韩式斜编发 2、韩式公主编发 3、夏日清凉编发（一） 4、夏日清凉编发（二） 5、韩式蜈蚣辫（一） 6、韩式蜈蚣辫（二） 7、韩式校园风编发 8、韩式显瘦发型（一） 9、韩式显瘦发型（二） 10、日常实用编发 11、升级花苞头 12、好媳妇包头 13、甜美乖巧发型 14、职场干练发型 15、范爷气质盘发（一） 16、范爷气质盘发（二） 17、大卷浪漫发型 18、居家生活发型 19、夏日清凉编发 20、唯美气质编发 21、韩式气质盘发 22、波希米亚风盘发 23、金鱼尾巴发型 24、金鱼辫子马尾 25、1分钟夏日扎发 26、韩式丸子头扎发 27、优雅盘发 28、公主鸡窝头 29、韩式温婉盘发（一） 30、韩式温婉盘发（二） 美发课堂---成就您的专业梦想 掌握时尚潮流，了解最世界潮流趋势 Ellipticity of elbow pipes with diameters less than or equal to 150 mm must be not greater than 8% diameter of 200 mm or less shall not be greater than 6%. Wall thickness of the pipe wall thinning rate must not exceed the original 15%. Crease roughness: diameter 125 mm or less, shall not exceed 3 mm diameter less than or equal to 200 mm, not more than 4 mm. 7.3.9 simmering bending production of square steel tube extension, to use the whole tube bending. Interface if necessary, the welding position should be located in the middle of the vertical arm. 7.3.10 install expansion joints should be done. If design is not required, pipe compensator lengthen should conform to the requirements in the following table: square scale length δ x is equal to 1/2. Pre stretch tolerance: casing + 5 mm, +10 mm. 7.3.11 pipe form, location, spacing shall meet the design and specifications. 7.3.12 piping on back or return pipe at higher levels of the upper to automatic valve to install a drain valve below the horizontal parts. 7.3.13 supports and hangers of checks and the number 1) hanger installed must be checked before installation of supports and hangers part models, specifications of springs setting values, whether the materials meet the requirements of drawings and documents; 2) supports and hangers of material, size and accuracy shall conform to the provisions of the design drawings, material technical requirements should be consistent with national standards, industry standards and technical requirements related to the alloy spectru