ISO5208-2008工业用阀门 金属阀门的压力试验概要1.docxVIP

Reference numberISO 5208:2008(E). ISO 2008INTERNATIONALSTANDARDISO5208Third edition2008-08-01Industrial valves — Pressure testing ofmetallic valvesRobinetterieindustrielle—Essaissouspression des appareils derobinetterie métalliquesISO 5208:2008(E)PDF disclaimerThis PDF file may contain embedded typefaces. In accordance with Adobes licensing policy, this file may be printed or viewed butshall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. Indownloading this file, parties accept therein the responsibility of not infringing Adobes licensing policy. The ISO Central Secretariataccepts no liability in this area.Adobe is a trademark of Adobe Systems Incorporated.Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creationparameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by ISO member bodies. Inthe unlikely event that a problem relating to it is found, please inform the Central Secretariat at the address given below.COPYRIGHT PROTECTED DOCUMENT. ISO 2008All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means,electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below orISOs member body in the country of the requester.ISO copyright officeCase postale 56 ??CH-1211 Geneva 20Tel. + 41 22 749 01 11Fax + 41 22 749 09 47E-mail copyright@Web Published in Switzerlandii . ISO 2008 – All rights reservedISO 5208:2008(E). ISO 2008 – All rights reserved iiiContents PageForeword ivIntroduction v1 Scope 12 Terms and definitions 13 Conditions relevant to pressure testing23.1 Purchaser examination options 23.2 Witnessing23.3 Closure pressure testing options 34 Requirements for pressure testing 34.1 Forewarning 34.2 Location 34.3 Test equ