QAM常见故障及维护(国外英文资料).docVIP

QAM常见故障及维护 This article is contributed by qhdgdjs DOC documents may experience poor browsing on the WAP side. It is recommended that you first select TXT, or download the source file to the local view. QAM common failures and maintenance recommendations, common failures and maintenance recommendations A RF output may be the cause of intermediate frequency link is not connected to the RF output set to off treatment suggestions through the network management with the random distribution of the intermediate frequency line connected intermediate link (output in the basic configuration in the control panel (RF) or in the output settings in the control menu) corresponding to the open output level the RF output IF requirements for 30dBmV IF (intermediate frequency) output level is lower, two, RF output level is low, RF output level is low, the level may cause RF cable is not connected or contact is bad, up converter may malfunction Treatment recommendations connected QAM modulator to RF cable STB the RF cable to connect the normal multi frequency test, because the level of each frequency point may be not the same error, the error level RF port more than plus or minus 5dB, it may already have inverter fault, at the same time can pass the test of RF TEST level than RF low output port 20dB to determine the cause (error should not exceed plus or minus 5dB) Three, equipment input stream interruption alarm equipment input stream interruption alarm may cause the input ASI, DS3, SPI cable is connected with the normal input interface type is correct setting treatment recommendations to ensure that the cable connecting well through the network management or panel set the input interface type (ASI, DS3, SPI) Four, the center frequency, the set-top box can decode STB causes output may be the normal number of modulation, symbol rate, spectrum inversion (only a few STB have the option) the parameters setting of QAM modulator and check QAM settings are not consistent and the set-top box