DBF-900型连续封口机常见故障分析(国外英语).docVIP

DBF-900型连续封口机常见故障分析(国外英语资料) Dbf-900 continuous sealing machine common failure analysis Added time: 2007/01/21 administrator: wang Chen Multi-function DBF - 900 type continuous sealing machine for plastic film is continuous sealing, stable performance and good sealing effect and the love of small and medium-sized food processing enterprises. In terms of flexible packaging bag, this machine has been widely used, when there is edge sealing, the sealing system of plastic film bags, bottom sealing fastness, it can use the machine to seal again, so as to achieve heat sealing quality requirements. This machine use after a long time, especially under the condition of continuous work, overload, prone to some electrical fault and mechanical fault, such as: sealing, machine stop-go, started in the operation of the blown fuse, issued a squeak, temperature control, pincer-like device finished bag deformation and bending, sealing knife embossed with bubbles or irregular mark lines, etc. Combining with the practical experience, in view of some fault, analyze its cause, puts forward the corresponding solutions, and expounds the maintenance of continuous sealing machine problem, want to use continuous sealing machine enterprise and individual help. The seal is not in jail The sealing is one of the common failures of the continuous sealing machine. The sealing of the packing bag cannot be sealed; Under the pressure of a knife-edge, the mouth of the bag was sealed, but it was crushed or torn, and the seal cracked. (3) to peel test pincer-like device, a half sealing strong, the phenomenon of separation, so the packing bag of the sealing quality is still not qualified, because the contents in the storage and transportation process integrated by extrusion is easy to miss. This situation is often seen in the compound as OPP and blow plastic PE. There are several reasons for the first failure. (1) the heat is not enough Normally, for OPP material in compound bag, bag when the total thickn