变压器装配工艺(国外英文).docVIP

变压器装配工艺(国外英文资料) With the rapid development of the power industry, a large number of power plants and substations have come into being. As the main electrical equipment of power plant and substation, the installation quality of transformer directly affects the safe operation of power grid. Therefore, the field installation technology of transformer is becoming more and more important. In this paper, starting from the actual construction, talk about 220kV power transformer on-site installation technology for reference to the working hours. 1 check the main transformer before installation (1) on the internal inspection of transformer, to be with good oil pipeline and pumping pipeline, pipe is the best galvanized seamless steel pipe, pipe internal to the derusting treatment before use clean heat transformer oil. (2) check whether the main body is affected with dampness. With oil transportation products, check the tank seal. The test of oil samples, and the detection coil insulation resistance and breakdown voltage, when the oil 50kV, 20 x 10-6, the rate of water coil insulation resistance and absorption ratio of R60 R60 / R15, the dielectric loss and the factory value has no obvious change, is considered not to be affected with damp. For moisture affected products, they should be dried when installed. 2 conditions for body inspection (1) when rain, fog or sand wind weather or relative humidity is greater than 75%, no body inspection can be carried out. (2) before the examination will be the best body temperature above the ambient temperature is heated to 10-15 DEG C (available hot oil circulation heating oil with U is larger than 50kV, the water content of 15 x 10-6, 90 DEG C when the dielectric loss of 0.5%.. (3) in the outdoor hanging hood inspection products, as far as possible to build temporary dust fence (with plastic sheeting), the wall is higher than the tank. 3 body check (1) inspection under normal conditions. Under normal circumstances, the 220kV transformer