海德堡故障处理2(国外英语).docVIP

海德堡故障处理2(国外英语资料) Printed data center - information center Heidelberg HD102V four color offset printing machine trouble repair Heidelberg HD102V four color offset machine (1) Failure 1: the brake device failed, and the machine flew after starting Reason: the circuit failure; Brake device imbalance (too loose); The copper cushion of the brake apparatus is damaged. To inspect the braking circuit and eliminate the failure; Loosen the brake to adjust the ends and tighten the screw, turning the ends clockwise Adjust the Angle and tighten the screw. Remove the brakes carefully and replace the copper cushion if it is not ready The product can be used for the use of the yellow copper leather or photoshopped with 0.3 mm thick, and be careful not to be misaligned or otherwise Faulty assembly resulted in a new failure. Because of the length of space, the detailed dismantling and adjustment method is a little bit. Failure 2: the host can not function or when good time is bad, there is a hot phenomenon, but the transmission device is normal Cause: circuit or commutator main motor failure; The brake device is out of balance (too tight); The brakes are not well maintained and dirty Too much, filling the gap between the chips; There is no immediate maintenance or other cause that causes the brakes to become too hot. The inner core steel strip is deformed, the resistance is sharp and the main engine is stopped. Repair: to inspect circuit motor and troubleshoot failure; Loosen the brake to tighten the screw and rotate counterclockwise Binding; Remove the brake, clean the parts and then assemble them according to the correct procedure. Part or all change of steel core And copper. Failure 3: when the main engine is running normally, the dot wheel follows, or when it stops Cause: the failure of the circuit or the contact between the end of the limit switch; The point of the actuator excitation line and the point wheel The face assembly space is too small, the rear shift is pressed tightl