ccna错题概要1.doc

窗体顶端 An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following subnet addresses can be configured in this network to provide a maximum of 14 窗体顶端 An additional subnet is required for a new Ethernet link between Router1 and Router2 as shown in the diagram. Which of the following subnet addresses can be configured in this network to provide a maximum of 14 useable addresses for this link while wasting the fewest addresses? 192.1.1.16/26 192.1.1.96/28 192.1.1.160/28 192.1.1.196/27 192.1.1.224/28 192.1.1.240/28 窗体底端 useable addresses for this link while wasting the fewest addresses? 192.1.1.16/26 192.1.1.96/28 192.1.1.160/28 192.1.1.196/27 192.1.1.224/28 192.1.1.240/28 窗体底端 窗体顶端 Refer to the exhibit. In the network that is shown, the router interfaces are assigned the first address in each subnet. Which IP address would be usable for a host on one of the LANs in this network? 192.168.1.5/30 192.168.2.17/28 192.168.2.63/27 192.168.2.130/25 窗体底端 What is a supernet? the network for a default route a network that contains both private and public addresses a set of discontiguous networks that are controlled by an ISP a summarization of serveral IP classful networks into one IP address range 窗体顶端 Refer to the exhibit. A network engineer is summarizing the two groups of routes on router R1 shown in the exhibit. Which summarization will work for all the subnets? 192.168.0.0/23 192.168.0.0/22 192.168.0.0/21 192.168.0.0/20 11.5.1 Redistributing an OSPF Default Route 窗体顶端 Refer to the exhibit. What does the O*E2 from the O*E2 0.0.0.0/0 [110/1] via 192.168.1.1, 00:05:34, Serial0/0 line represent? an internal type 2 OSPF route. an external OSPF route at least two hops away. an external OSPF route from two different sources. an external OSPF route that will not increment in cost. a default route. The route was distributed into OSPF from a type 2 router. 窗体底端 窗体顶端 Th