布草井设计要求Laundry Chute - Typical Constructional Details (English Chinese).pdfVIP

CONSTRUCTIONAL DETAILS OF LINEN CHUTE 污衣筒构造细节 Intake Section 投入口部分 Linen Chute Intake Doors are fabricated of Type 304 stainless steel and bear the Underwriters Laboratory 1.5 Hour B. Doors are pre-hung and equipped with positive latching and single motion T-handle equipped with cylinder locks keyed alike. All doors are self-closing and self latching. All intake doors can be equipped with electric interlocks as an option. 污衣筒投入口门是由 304 型不锈钢(1.5mm 厚)制作的且达到 Underwriters 试验室 1.5 小时 B级放火门 要求. 门是预挂式的并装备有容易闭上及单手操作的T 把手, 把手本身带有圆柱型的通用锁的锁芯. 所有 门可以自动关闭并闭锁. 所有投入口门也能选用带有联动装置的电动锁. Door and frame are mounted into intake throat with sheet metal screws into anchor plate and straps welded to intake throat making door and frame readily removable for repair or replacement without marring the finished wall. 投入口门及门框装在入口孔, 并使用金属螺丝固定, 绑带式的焊接到入口孔处. 门及框在不会损坏墙面的 情况下易于移动,拆卸下来维修或更换. Floor support grid: Floor support grid 3/16 flat stock welded to steel angles 1/4 x 1 1/2 x 1.5. 楼层支持架: 楼层支持架为 3/16’’平行条与 1/4 x 1 1/2 x 1.5角铁焊接. Linen Chute Intake Doors 布草筒投入口门 • Side-hinged, hand operated, self closing, stainless steel intake door assembly. Doors bear, 1.5 hours 250 Degree F, U. L. B label. 投入口门为边挂式,手动操作, 自动关闭的不锈钢门装配.门可达到 1.5 小时华氏 250 度 B级放火门要求. • Unexposed side of door will not exceed 250 degrees F within the first 30 minutes of a fire test. 防火测试时, 首 30 分钟,门的隐蔽边的温度将不会超过华氏250 度. • Surfaces of the door and frame are unmarred by lapped joints, bolt on style trim, screws or rivets. 门的表面及门框不应有重叠点,螺钉,螺丝及铆钉损坏点. • Trim is 18 gauge stainless welded and polished integrally with the door. 门框边饰为 18 级不锈钢，磨光完整地与门焊接 • Door and frame are completely removable from intake section without marring wall. Recommended height of intake door: 30” to the bottom of the intake door. 门和门框可在不用损坏墙面的情况下便可将完整地从入口部分移开.班 建议投入口门的高 度：投入口门的底部离地 30’’. Recommended Intake Door Sizes: 建议投入口门的尺寸