蜂鸣器奏乐(国外英文资料).docVIP

蜂鸣器奏乐 Program function: MCU control buzzer playing song I wish you peace. ---------------------------------------------- Dial switch settings: BUZZER bit to ON, and the other bits to OFF Test note: listen to the buzzer sing music Since its playing music, there should be two parts for a note First, the tone two is the duration, in which the tone is simple Delay - level reversal is achieved, and the time to change the delay is changed Tone, and time is achieved by counting and comparing, when the count value is equal Jump out of the loop and play the next note. *********************************************/ #include msp430x14x.h Typedef unsigned char uchar; #include music.h #define Buzzer BIT7 #define Buzzer_Port P6OUT #define Buzzer_DIR P6DIR Uchar counter; Void Play_Song (void); The main function of ****************/ /*************** Void main (void) { Uchar i; * the following six lines of code to close all IO. P1DIR = 0XFF; P1OUT = 0XFF; P2DIR = 0XFF; P2OUT = 0XFF; P3DIR = 0XFF; P3OUT = 0XFF; P4DIR = 0XFF; P4OUT = 0XFF; P5DIR = 0XFF; P5OUT = 0XFF; P6DIR = 0XFF; P6OUT = 0XFF; P6DIR BIT2 P6OUT |= |=; BIT2; / / close level conversion WDTCTL = WDTPW + WDTHOLD; / / close watchdog The master clock for the 8MHz-------*/ /*------ selection system BCSCTL1 = ~XT2OFF; / / open XT2 high frequency crystal oscillator Do { IFG1 = ~OFIFG; / / clear crystal failure marks For (I = 0xFF; I 0; i--); / / wait for 8MHz crystal oscillator } While ((IFG1 OFIFG)); / / Crystal failure signs still exist? BCSCTL2 |= SELM_2 + SELS; / / the master clock and the clock are selected from high-frequency crystal oscillator A / / set the timer interrupt every 10ms CCTL0 = CCIE; CCR0 = 10000; / / change the value change tempo TACTL |= TASSEL_2 + ID_3; / / IO direction control buzzer output settings Buzzer_DIR Buzzer |=; / / open global interrupt _EINT (); Play the song / cycle While (1) { Play_Song (); } } /******************************************* Function name: TimerA_ISR Function: interrupt se