交换与路由五概要1.pptVIP

RIP协议 配置RIP 启用RIP协议 RIP 配置示例 使用passive-interface命令的意义 阻止RIP协议更新从某接口发送出去 配置passive-interface 检查RIP配置 查看路由表 配置RIP v2 检查RIP配置 检查RIP配置 * RIP协议 19.2 kbps T1 T1 T1 A B Router(config)#router rip Router(config-router)#network network-number network number必须是主网号(no subnet). 通告网络 2.3.0.0 router rip network 172.16.0.0 network 10.0.0.0 router rip network 10.0.0.0 2.3.0.0 router rip network 192.168.1.0 network 10.0.0.0 172.16.1.1 S2 E0 S3 192.168.1.1 10.1.1.1 10.2.2.2 10.1.1.2 S2 S3 10.2.2.3 172.16.1.0 A B C 192.168.1.0 E0 Router(config-router)# passive-interface type number 192.168.3.1/24 172.16.2.1/24 172.16.1.1/24 S0 S1 E0 X 192.168.3.1/24 172.16.2.1/24 172.16.1.1/24 S0 S1 E0 2.3.0.0 router rip network 172.16.0.0 network 192.168.3.0 passive-interface E0 X RouterA#sh ip protocols Routing Protocol is rip Sending updates every 30 seconds, next due in 0 seconds Invalid after 180 seconds, hold down 180, flushed after 240 Outgoing update filter list for all interfaces is Incoming update filter list for all interfaces is Redistributing: rip Default version control: send version 1, receive any version Interface Send Recv Key-chain Ethernet0 1 1 2 Serial2 1 1 2 Routing for Networks: 10.0.0.0 172.16.0.0 Routing Information Sources: Gateway Distance Last Update 10.1.1.2 120 00:00:10 Distance: (default is 120) 172.16.1.1 S2 E0 S3 192.168.1.1 10.1.1.1 10.2.2.2 10.1.1.2 S2 S3 10.2.2.3 172.16.1.0 A B C 192.168.1.0 E0 172.16.1.1 S2 E0 S3 192.168.1.1 10.1.1.1 10.2.2.2 10.1.1.2 S2 S3 10.2.2.3 172.16.1.0 A B C 192.168.1.0 E0 RouterA#sh ip route Codes: C - connected, S - static, I - IGRP, R - RIP, M - mobile, B - BGP D - EIGRP, EX - EIGRP external, O - OSPF, IA - OSPF inter area N1 - OSPF NSSA external type 1, N2 - OSPF NSSA external type 2 E1 - OSPF external type 1, E2 - OSPF external type 2, E - EGP i - IS-IS, L1 - IS-IS level-1, L2 - IS-IS le