cad高级技巧（国外英文资料）.docVIP

cad高级技巧 Defaults to the new version of the settings: Tools - Options - System - start - show start dialog - ok. Unit: decimal angle: decimal angle starting direction: Orient direction: counter clockwise is positive direction Region: A3, 420mm, 297mm Open the CAD tool: View - toolbar - draw, modify, mark, capture, tick, etc. (right-click on the frequently used toolbar also opens) Roller scrolling can zoom in and out on images. Hold the roller and drag to move. Straight line: L orthogonal: F8 Create more than two lines, enter C closed, U can be cancelled. ESC can uncheck the exit abort command. Space / carriage return: repeat the previous operation. Offset: o Method: select offset - the input offset distance, carriage return - the direct single line segment, in the direction of the desired offset click - right end. Trim: tr (trim the excess line segments across the cross) Method: select trim - right-click in the space - left click on the trimmed pair - right button to make sure its over. Single time trim: select trim - left click, reference to image - right-click in space - enter F, enter - - Click two to create a line segment (across all trimmed segments) - right end. Extension: EX Method: select extension - right click - left click on the extended image - the right button determines the end Single quick extension pair: select extended left click the extended pair right click enter F carriage return - Click two to create a line (this line must select all the extensions to the image) - right-click. Circle: C Method: 1, drawing - circle - center and radius (diameter) - click the center of the circle - enter the radius / diameter, enter 2, drawing - round - two points / three points - direct point 2 points /3 points. 3, drawing - circle - tangent tangent radius - click the first point of tangency - click the second point of tangency - Enter the input radius (circle and circle / line / line and circle line) 4, drawing - circle - tangent, tangent, tangent - click three po