DOS命与条打维修（国外英文资料）.docVIP

DOS命与条打维修 400.8210133 2.1 button and indicator status br Button description br Press the FEED button and the printer leaves the paper offline; br Press and hold the FEED key to turn on, and the printer enters the medium induction mode br ? Indicator Status note br Flashing green: possible: the printer is in auto induction mode; the printer is downloading fonts, graphics, and formats. br Stable green: possible: the printer is in the ready mode; the printer is in print mode; the printer is in DUMP mode. br Stable orange, possible: printer in boot mode. br Flashing red: possible: printer card; print head overheating; stepper motor overheating; printer is downloading Firmware. br The printer is not possible: fixed red, medium or ribbon printer in the wrong mode. brbr 2.2 label paper installed br 2.2.1 Tear-off mode subscript paper installation br Press the upper cover opening button at both ends of the printer to open the top cover. br Insert the label roll onto the label mandrel. br Place the label scrolls on the two bayonet. br Press the locking mechanism on both sides to open the printing mechanism. br Push the label guide slot so that the label passes through the slot. br The guide card slot to adjust the label label width. br 2.2.2 stripping mode, subscript paper installation, br Press the upper cover opening button at both ends of the printer to open the top cover. br Insert the label roll onto the label mandrel. br Place the label scrolls on the two bayonet. br Press the locking mechanism on both sides to open the printing mechanism. br Open the stripping mechanism. br The open label guide card slot, let the card slot through the label. br The guide card slot to adjust the label label width. br The label start off at the end of paper 10cm. br To the bottom paper around the peeling roller, into the stripping mechanism, from the past br slot stripping mechanism The pull tab medium, while pulling the bottom paper until the end of the paper has been straightened. br