E水电木瓦油（国外英文资料）.docVIP

E水电木瓦油 I. waterway (I) waterway reconstruction 1, material: PPR pipe and pipe fittings 2, advantages: (1) corrosion resistance, PPR is non-polar polymer, chemical inertness is good, to the ions in water and chemical substances in the building can not play any chemical action, no rust, no corrosion (2) good hydraulic performance, smooth inner wall, low noise of conveying water, small resistance, higher flow rate than galvanized pipe 30%, no scaling, no bacteria (3) good temperature resistance, long service life, long-term use temperature of 70 degrees, up to 95 degrees, at 70 degrees temperature, pressure 1.0MPA, life expectancy of up to 50 years. (4) the heat preservation and thermal conductivity are only 0.2W/m.k, and the thermal conductivity is only 1/200 of the metal tube. 3, process flow: Crossed slot hole positioning - - - acceptance - cement mortar pipe seal 4, matters needing attention: (1) waterway construction, according to the actual situation of kitchen and toilet and customer demand, reasonably determine the various water points, such as: location and pipeline valve, faucet, shower, angle valve path crossed position. (2) buried pipeline, Zaoqiang geosyncline should ensure depth of buried pipeline in metope, ground powder after repair should not be exposed, should avoid digging trench level, prevent the destruction of building structure. (3) PP-R pipe installation layout is reasonable, horizontal and vertical, the pipeline shall not be near the power supply, and the shortest distance between the power line is 200mm, the pipeline and sanitary appliances are closely connected. (4) water pressure test is completed, must use cement mortar filling. (5) when reforming the waterway, attention shall be paid to the orientation of the pipeline and the requirements of the location, height and dimension of the reserved interface and angle valve. The installation height of the water supply pipe of the toilet is generally 250mm from the ground to the angle valve center