二极管三极管的测量（国外英文资料）.docVIP

二极管三极管的测量 Measuring diode with diode meter of digital multimeter. When measuring diode, use the meters diode gear. If the red pen is connected with the diode Yang (positive), the black pen is connected with the diode Yin (negative), the diode is biased, multimeter has a certain numerical display. If the red pen is connected with the cathode, the black pen is connected with the diode anode, the diode is reverse biased, multimeter display for high value 1 or large, when the diode is good. In the measurement, if two times the value is very small, then the diode internal short circuit; if the two measurements are very large or high to 1, then the diode internal open circuit 2. use digital multimeter to measure the triode (1) measure the type of triode and base B with diode meter of digital multimeter When judging, the triode can be regarded as a back-to-back PN junction, as shown in figure 2.1. According to the method of judging the diode, it can be determined that one pole is a common positive pole or a common negative pole, and the pole is the base B. For NPN type tubes, the base is a common positive electrode, and the PNP type tube is the common negative electrode. Therefore, to determine whether the base is a common anode or a common negative electrode, it is known that the transistor being measured is a NPN or PNP type triode. (2) the determination of emitter E and collector C Using the meter to measure the value of the beta (HFE), the emitter E and the collector C are determined. The gear is rotated to the MFE base and inserted into the corresponding type of Kong Zhong. The pins are inserted into the C and e holes respectively to observe the data, and then the pins in the C and e holes are switched to look at the data. The numerical value shows that the pins are inserted correctly. (3) distinguish the good or bad of triode When testing, use the multimeter to measure the diodes gear, test the triode emitter, the collector nodes positive and negative bias respective