沃尔沃液压系统维修手册.doc

Hydraulic system, bleeding Op nbr?Tool:935537 Elbow nipple944521 Hose943471 Hose clamp Things to consider after replacing hydraulic components: Inspect the hydraulic oil tank and clean it if necessary. The bar magnet of the return oil filter must be cleaned (if fitted). The return oil filter must be inspected and replaced if the filter has visible impurities. If the running time of the machine is more than 50% of the filters normal replacement interval, the filter should be replaced. All hydraulic oil, both new and reused, must be filled via the hydraulic oil tanks return filter. To be able to reuse the oil, it must be completely free of any dirt and impurities. 牋Warning! Hot hydraulic oil and hydraulic oil under pressure may result in severe personal injuries Start the engine and let it go to low idling speed for about 15 minutes without activating any hydraulic functions. Activate all hydraulic functions a few times with the engine running at low idling speed. NoteThe hydraulic cylinders must not be run to their end positions. Lift up the boom to its upper end-position, without building up pressure. NoteIts very important that no pressure is built up even when the function is run to its end-position. Lower the boom. Lift up the boom so that the tilt cylinder is horizontal to the ground. Carefully tilt back without building up any pressure. Switch off the engine.Fill hydraulic oil in the hydraulic oil tank, if needed. If air bubbles are seen in the tank, leave the engine off for approx. ten minutes. Bleed the brakes, see Brake system, bleeding. Lift up the boom all the way, and tilt forward completely. NoteIf the lift cylinders or several components in the hydraulic system have been completely drained of hydraulic oil, the lift cylinders must be bled using the bleeder nipples on the cylinders (1 nipple per cylinder). Its advantageous to use elbow nipple 935537, hose 944521 as well as ev. hose clamp 943471 to prevent oil spills. Lower the boom and turn