带式输送机产品质量计划英文概要1.docVIP

Inspection Test Plan of Belt conveyor General This plan specifies belt conveyor quality objectives in the product realization process during different stages, aimed at effectively controlled quality in the product realization process of each stage and ensures the quality of products to meet customer requirements. This plan is suitable for belt conveyor product general quality plan. For a special contract or customer for some terms with special needs, we deal with relevant clause to be amended by technology, informs to each executive branches as a product quality planning attached documents. Responsibility 2.1The sale department transfer contract information to technology department. 2.2The technology department design the customer need and amend product quality plan. 2.3Allrealtive departments and manufacturing department carry out and control the quality plan. The quality plan control specification 3.1The technology department carry out as《Design and develop control Procedure》 3.2The purchasing department carry out as《purchasing Control Procedures》 3.3purchased and raw materials should be inspected as《Raw material and Purchased products works Inspect Procedures》 3.4 Quality Control of Special Procedures 3.4.1Heat Treating procedure 1）Drive pulley shaft hardness:217～255HB； 2）Roller brake shaft hardness:60～65HRC； 3）Roller brake insert hardness:60～65HRC； 3.4.2Welding procedure 1）Pulley shell weld seam should be as Class BⅡof GB11345-1989 or Class Ⅲof GB/T3323-2005. 2）No crack or non-penetration seam is allowed to between of pulley shell and end disc. 3）No crack, breakthrough or non-melted weld seam is allowed on steel structure. 3.5 Cooperated-parts Inspection 3.5.1 Cast steel is required as following: 1）The cast steel should be relieved stress. 2）The size should be as the technology requirement 3）The material should be as the drawing requirement 4）No crack, sand and added parts is on the appearance. 3.4.2Pulley lagging should be accorded as below 1）Rubber physica