西安电子科技大学数字信号处理上机作业.docxVIP

数字信号处理MATLAB上机作业M2.2题目The square wave and the sawtooth wave are two periodic sequences as sketched in figure P2.4.Using the function stem. The input data specified by the user are: desired length L of the sequence, peak value A, and the period N. For the square wave sequence an additional user-specified parameter is the duty cycle, which is the percent of the period for which the signal is positive. Using this program generate the first 100 samples of each of the above sequences with a sampling rate of 20 kHz ,a peak value of 7, a period of 13 ,and a duty cycle of 60% for the square wave. 程序% 用户定义各项参数参数A = input(The peak value =);L = input(Length of sequence =);N = input(The period of sequence =);FT = input(The desired sampling frequency =);DC = input(The square wave duty cycle = );% 产生所需要的信号t = 0:L-1;T = 1/FT;x = A*sawtooth(2*pi*t/N);y = A*square(2*pi*(t/N),DC);% Plotsubplot(2,1,1)stem(t,x);ylabel(幅度);xlabel(n);subplot(2,1,2)stem(t,y);ylabel(幅度);xlabel(n);结果结果分析M 2.4题目Write a matlab program to generate a sinusoidal sequence x[n]= Acos(ω0 n+Ф) and plot the sequence using the stem function. The input data specified by the user are the desired length L, amplitude A, the angular frequency ω0 , and the phase Ф where 0ω0 pi and 0=Ф=2pi. Using this program generate the sinusoidal sequences shown in figure 2.15.Generate sinusoidal sequences with the angular frequencies given in Problem 2.22. Determine the period of each sequence from the plot and verify the result theoretically.程序%用户定义的参数L = input(Desired length = );A = input(Amplitude = );omega = input(Angular frequency = );phi = input(Phase = );%信号产生n = 0:L-1;x = A*cos(omega*n + phi);stem(n,x);xlabel(n);ylabel(幅度);title([\omega_{o} = ,num2str(omega)]);结果ω0=0ω0=0.1πω0=0.8πω0=1.2πω0=0.14πω0=0.24πω0=0.34πω0=0.68πω0=0.75π结果分析M 2.5题目Generate the sequences of problem 2.21(b) to 2.21(e) using matlab.程序(b)n = 0 : 99;x=sin(0.6*pi*n+0.6*pi);stem(n,x);xlabel(n);ylabel(幅度);(c)n = 0 : 99;x=2*cos(1.1*pi*n-0.5*pi)+2*sin(0.7*pi*n);stem