动态多主元模型故障检测方法在变工况过程中的应用.pdfVIP

　第 25 卷 第 4 期 动 　力 　工 　程 Vol. 25 No. 4 　 　2005 年 8 月 Aug. 2005 　 ( ) 　　文章编号 2005 动态多主元模型故障检测方法在变工况过程中的应用 牛　征 , 　刘吉臻 , 　牛玉广 (华北电力大学 自动化系 ,保定 071003) 摘 　要 : 提出了一种适用于变工况过程的动态多主元模型故障检测方法。首先对过程数据进行分 类得到各稳态工况下的数据 ;然后根据分类数据建立主元模型组来描述整个过程的统计特性 ;最后 在故障检测中根据检测样本对分类数据的隶属度和主元模型组计算出与当前工况相适应的主元模 型并进行检测。以火电厂锅炉过程为例对比研究了传统方法和新方法的应用情况。试验结果表明 新方法能适应工况变化 ,减少误检并提高了检测灵敏度。图 6 表 1 参 10 关键词 : 自动控制技术; 变工况过程 ; 主元分析 ; 故障检测 ; K均值聚类分析 中图分类号: TP277 　　　文献标识码 : A Fault Detection Under Varying Load Conditions Based on Dynamic MultiPrincipal Component Models NIU Zheng , 　LIU Jizhen , 　NIU Yuguang (Department of Automation , North China Electric Power University , Baoding 071003 , China) Abstract : Traditional PCA fault detection methods are designed for simple steady working conditions and may occasion erroneous conclusions if used for frequently changing working conditions. A new detection method based on dynamic multiprincipal component models is being proposed for this purpose. First process data for various steadystates are obtained by data classification , then principal component model groups are established to describe the statistical features of the whole working process. Finally during fault monitoring a PCM fitting current working conditions are calculated according to membership of the classified detection data samples and the principal component model group. With a fossil fired power plant boiler as an example , comparisons between traditional methods and the new one show that the new method has good adaptability