美国ubnt wifi设备 AirOS无线中继器配置.docxVIP

AirOS Wireless Repeater Configuration Contents ?[ HYPERLINK javascript:toggleToc() hide]  HYPERLINK /AirOS_Wireless_Repeater_Configuration \l AirOS_Wireless_Repeater.2FNetwork_Extender_Configuration 1?AirOS Wireless Repeater/Network Extender Configuration  HYPERLINK /AirOS_Wireless_Repeater_Configuration \l Introduction 1.1?Introduction  HYPERLINK /AirOS_Wireless_Repeater_Configuration \l Configuring 1.2?Configuring  HYPERLINK /AirOS_Wireless_Repeater_Configuration \l AP_.231_Setup 1.2.1?AP #1 Setup  HYPERLINK /AirOS_Wireless_Repeater_Configuration \l AP_.232_Setup 1.2.2?AP #2 SetupAirOS Wireless Repeater/Network Extender Configuration Author:? HYPERLINK /User:Skyhook \o User:Skyhook Skyhook?01 March 2009Contents: How to make a Wireless Repeater AirOS Introduction  HYPERLINK /wiki/Repeater \o /wiki/Repeater Wireless Repeater?or Network ExtenderFrom? HYPERLINK /forum/viewtopic.php?t=7204 \o /forum/viewtopic.php?t=7204 UBNT Forum Typical scenario is to install a Network Extender device to provide wireless signal to Clients that cannot be reached from?AP #1?(poor signal level). We consider this simply network topology: 1?Router?connected to Internet and/or private LAN (IP Address: 54/24) 1 AirOS device?AP #1?directly connected to Router (IP Address: 1/24) 1 AirOS device?AP #2?connected via wireless to?AP #1?(IP Address: 0/24) 1 or more Wireless Clients (Notebook, WiFi-Phone, other Wireless devices...) The Router assign IP Address to network devices by DHCP Server. Alternatively, if you prefer, you can set static IP Address to Clients. In this schema,?AP #2?is a Wireless Repeater device. Configuring Minimal configuration: all AirOS devices in?AP-WDS?mode same?SSID same?Channel enter mutual?WDS Peers?(or enable?Auto WDS, not recommended) AP #1 Setup Login into AirOS WEB User Interface of?AP #1?and set as below: NETWORK?Tab Network Mode:?Bridge Bridge IP Address:?Static IP Address:?1 Netmask:? Gateway IP:?54 Click?Change?button to confirm Cl