2011普通高校招生试题汇编功和能的关系（2011, college entrance examination questions compilation work and energy relationship）.docVIP

2011普通高校招生试题汇编功和能的关系（2011, college entrance examination questions compilation work and energy relationship） 2011, college entrance examination questions compilation: work and energy relationship 1 (2011 Jiangsu fourth title). As shown in the picture, the actors are performing acrobatics. Can be estimated by he will process an egg thrown in the egg of the work done by the closest to A.0.3J B.3J C.30J D.300J 2 (2011 national Volume 1, Twentieth title). The quality is M, the inner wall spacing is L, the box is resting on the smooth horizontal surface, in the box has a quality m small material block, between the small material block and the box bottom board dynamic friction factor is mu. At the beginning, the small blocks are parked in the middle of the box, as shown. The small block is now a horizontal to the right of the initial speed of V, small pieces and box wall collision N times, just returned to the middle of the box, the well and the box remained relatively static. If the collision is elastic, then the kinetic energy of the loss of the system is A.B.C.D. Analysis: the final velocity of the two bodies is equal to u, and the momentum is conserved as follows: mv= (m+M) u, and the kinetic energy of the system loss is: The kinetic energy of system loss is transformed into internal energy Q=fs= 3. (Sichuan nineteenth). The figure is sketch of the Shenzhou series of spacecraft re-entry capsule returned to earth, assuming that the process can be simplified to: open the parachute after a period of decline of the whole device is constant, in order to ensure a safe landing, to buffer rocket is fired the capsule, the capsule in rocket jet process do you speed linear motion. The A. rocket begins to jet, and the parachutes pull on the re-entry capsule is smaller B. re-entry module slows down during the jet process because of air resistance The C return capsule may perform positive work during the jet flow The D. re-entry module is weightless during the jet process Analysis: