FAQ-背板带宽 计算公式,背板带宽与端口速率（FAQ - backboard bandwidth calculation formula, backboard bandwidth and port speed）.docVIP

FAQ-背板带宽 计算公式,背板带宽与端口速率（FAQ - backboard bandwidth calculation formula, backboard bandwidth and port speed） What is the origin of the so-called 128kbps in the telecommunications department? A: at present, the 2Mbps bandwidth of our telecom users is converted into bytes. 2 * 1000 KBPS / 8 bit = 256 Kbyte/s The back-plate bandwidth calculation formula, the backplate bandwidth and the port speed 1. The calculation formula explains the backboard bandwidth of the switch. It is the maximum amount of data that can be swallowed by the switch interface processor or the interface card and the data bus. The backboard bandwidth marks the total data exchange capacity of the switch, and the unit is Gbp. It also narrate the bandwidth. The backboard bandwidth of the general switch ranges from several Gbp to hundreds of Gbp. The higher the backboard bandwidth of a switch, the stronger the ability to process data, but also the higher the cost of design. Generally speaking, the calculation method is as follows: (1) the backboard bandwidth of the line speed is used to check the total bandwidth provided by all ports on the switch. The calculation formula is the number of ports tie; Corresponding port rate tie; 2 (full duplex mode) if the total bandwidth is less than the nominal backboard bandwidth. So its line speed on the backboard bandwidth. (2) second-layer packet forwarding rate = gigabit port number tie; 1.488 Mpp + 100 MB port number tie; 0.1488 Mpp + other type ports tie; The corresponding calculation method, if this rate can be less than or less than the second layer packet forwarding rate, the switch will be able to line the second layer. (3) the forwarding rate of the third layer of the forwarding wire is the number of gigabit ports. 1.488 Mpp + 100 MB port number tie; 0.1488 Mpp + other type ports tie; The corresponding calculation method, if this rate can be less than or equal to the three-layer packet forwarding rate. So the switch can do the line speed while doing t