THERMO培养箱---中文说明书（THERMO incubator - Chinese manual）.doc

下载文档 降价啦

173
0
约2.34万字
约 26页
2017-07-15 发布于河南
举报
版权申诉
保障服务

THERMO培养箱---中文说明书（THERMO incubator - Chinese manual）.doc

1、本文档共26页，可阅读全部内容。
2、原创力文档（book118）网站文档一经付费（服务费），不意味着购买了该文档的版权，仅供个人/单位学习、研究之用，不得用于商业用途，未经授权，严禁复制、发行、汇编、翻译或者网络传播等，侵权必究。
3、本站所有内容均由合作方或网友上传，本站不对文档的完整性、权威性及其观点立场正确性做任何保证或承诺！文档内容仅供研究参考，付费前请自行鉴别。如您付费，意味着您自己接受本站规则且自行承担风险，本站不退款、不进行额外附加服务；查看《如何避免下载的几个坑》。如果您已付费下载过本站文档，您可以点击这里二次下载。
4、如文档侵犯商业秘密、侵犯著作权、侵犯人身权等，请点击“版权申诉”（推荐），也可以打举报电话：400-050-0827(电话支持时间：9:00-18:30)。

THERMO培养箱---中文说明书（THERMO incubator - Chinese manual）

THERMO培养箱---中文说明书（THERMO incubator - Chinese manual） THERMO FORMA 370/371 380/381 High temperature sterilization, air jacket CO2 culture box operation manual directory One. Parameter Settings 2. Parameter calibration Iii. System information 4. Alarm information V. high temperature disinfection One, parameter setting A setting temperature Thermo Forma 370 series co2 incubator working temperature in the range of 10 ℃, 50 ℃, the temperature is influenced by environmental temperature. Factory, the factory is to set the temperature 10 ℃, under this setting, all of the heater will be closed. To set the temperature, follow these steps: Press MODE to SET. 2. Press go until the TEMP XX. X information is displayed 3. Set the temperature required by the arrow down setting. 4. Press ENTER to save the set value. 5. Click MODE to RUN or select other parameters according to go. B. Set temperature temperature The co2 incubator in the 370 series has the second-level temperature monitoring system to monitor the temperature inside the box body. This is a self-protection function of the machine. Once the temperature is out of control, the machine will turn off all the heaters. The casing of the alarm temperature is + / - 1 ℃ temperature temperature. Factory set temperature 40 ℃, the temperature is but a highest temperature temperature can be set at 55 ℃. If the temperature is higher than the thermal setting, the machine will give a warm 1 ℃ temperature automatically. The general thermal 1 ℃ temperature should be higher than the set temperature. Follow these steps to set the temperature: Press MODE to SET. 2. Press go until the O TEMP XX. X information is displayed. 3. According to the up and down setting, the temperature and temperature required. 4. Press ENTER to save the set value. 5. Click MODE to RUN or select other parameters according to go. C. Set CO2 concentration Incubator, with an T/CCO2 sensor factory factory has a calibration, the calibration when the environment temperatu