变频器的主电路如何上电检修（How does the main circuit of frequency converter go to electric maintenance）.docVIP

变频器的主电路如何上电检修（How does the main circuit of frequency converter go to electric maintenance） How does the main circuit of the converter go up and overhaul the saltier article The inverter must set up the idea that the inverter module and the driver circuit have a strong connection to failure. When the damage of the module is broken, the drive circuit will be damaged. The damage to the module can also be caused by the failure of the driver circuit. Therefore, the inverter output circuit must be thoroughly checked with the driving circuit, regardless of the fault of the driving circuit or the inverter output circuit. On the main circuit, it is necessary to make sure the driving circuit is normal. See chapter 4 for the overhaul of the drive circuit. After checking the driving circuit, it will damage the inverter and replace it. The electric test machine after the machine is assembled is an event that must be carefully engaged. Corresponding measures must be taken to ensure that the new IGBT module is not damaged when abnormal conditions occur. During the test, the frequency converter startup moment is the most fatal moment, without the protection of the rush of the power, will make the new value of the expensive module damaged in an instant. Previous efforts to overhaul the system have not only whiten away, but have also caused greater losses, potentially widening the range of failures. Some maintenance personnel have Fried several modules, then the frequency converter maintenance is discouraged. Taking the corresponding electric test measures, it can basically eliminate the occurrence of the damage of the inverter module, so as long as it is careful, there is no problem. Method 1: to disconnect the power supply of the inverter module, in fact, to connect the copper platoon in the circuit, and to remove the connecting copper platoon, the current power supply end of the three-phase inverter circuit is disconnected. Note: the cut-off point must be after the energy storage