家装知识（Domestic outfit knowledge）.docVIP

家装知识（Domestic outfit knowledge） First, hydropower projects (1) circuit engineering 1. All electrical control lines and lines must be PVC piping. 2. If there is a negative Angle in the canopy, the line will go from the wall. 3. The same circuit wire shall be laid in the same pipe, the diameter of the wire shall be suitable, and the length of the tube shall be no more than 40% of the cross-sectional area of the PVC pipe. 4. The bending of the wire shall not be greater than 90 degrees, and shall be connected with a pipe fitting more than 90 degrees. 5. The strength and weakness of the wire through the tube must be separated and worn. 6. Joint is firm and reliable, good insulation performance (value greater than 0.5 M Ω). 7. The line layout is reasonable. 8. The fixed position of the switch socket must meet the requirements, i.e. the switch is 1200-1300MM away from the ground and the socket is 300-450mm from the ground. 9. The lines are clear and orderly. 10. The indoor area is more than 40 square meters and the air conditioning line should be laid with 4 square mm BV copper core wire. 11. A 2.5mm BV copper core line should be laid in the electrical outlet. 12. The line should be laid 2.5 square mm BV copper core line as the main line, 1.5mm BV copper core wire is the dividing line. 13. The top of the ceiling must be in tube, and in the same time, the pipe fitting shall not be placed on the ceiling, usually from the top 100 to 200MM. Concealed pipe line is laid: the thickness of line tube to cement mortar is not less than 15MM. 15. The length of line tube in the wire box shall not be greater than 0.5mm, and the sleeve shall be set. 16. All lines must have grounding and leakage protection. 17. All wire joints must meet the requirements of building codes. 18. No joint inside the pipe, the inside of the junction box is allowed to be left, the joint is welded and wrapped. (2) waterway engineering 1. All connectors are strong, reliable and well sealed. 2. The water outlet of