氨缓冲罐问题（Ammonia buffer tank problem）.docVIP

氨缓冲罐问题（Ammonia buffer tank problem） Indicate that the flange welding of the equipment is finished. Pipe flange forging with 16Mn forging. Two pipe flanges need to be calculated for the hole reinforcement The equipment can be soldered automatically, indicating automatic welding joint and welding rod selection. By the way, why do you want 100%? Because of the welding seam coefficient is 1, 100% shooting for, of course can choose the coefficient of 0.85 20% RT, but cant say it wrong, tube flange forging with 16 mn Ⅱ is right, not the 16 mn forging, Technical error (blunder) : 1. The support material is returned, and the material of the q235-a / 16MnR mat should be marked in the back 2. The main pressure increase 16 mn Ⅱ materials The technical feature table does not specify the dielectric feature (also the small fault). Small mistake: not a lot, if all CD kind of welds require 100 % MT a bit too much, the corrosion allowance of 3 have what basis (heavy corrosion?) The flange of the equipment has no nodal diagram, the concave surface and the convex surface which are not clearly defined, how to make the factory. No nameplate location. The supporting block is marked with 4 pieces of all cloth, pressure ring and so on. Take over the material 20 forging mark wrong, must use forging piece also not such standard method. The heat treatment of the equipment after integral welding may not be such a high requirement. In addition, there is no straight edge height of the head. Neither indicated nor reflected in the detail column. In general, mistakes are not too many, and the general feeling improves the design requirements. Ammonia is not a dangerous medium. The personal views are discussed in a few different ways with pretty. 1) cause and effect, when the design not for weld radiographic testing length coefficient of 1, so only 100% of RT, I think should be determined by equipment situation 100% RT and then need to weld coefficient 1. This equipment is local test is ok, I think,