深基坑支护中土层的锚杆设计与施工（The design and construction of anchor rod in deep foundation pit support）.docVIP

深基坑支护中土层的锚杆设计与施工（The design and construction of anchor rod in deep foundation pit support） -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Page 1 -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- -- Private science and technology Construction planning · design phase 5 of 2008 The design and construction of anchor rod in deep foundation pit support Chen Zeng new (shenzhen municipal engineering design institute limited company, guangdong shenzhen 518029) Abstract: from the Angle of bolt design, this paper analyzes the application of anchor strength method in the special ground level, and analyzes the form of water grouting for the bolt. Key words: deep foundation pit support; Ground bolt Design; The construction of the Introduction package. Deep foundation pit supporting works are used for piling up and supporting the supporting structure, but the operation of the secondary high pressure grouting is more complicated. The sealing problem of embedded flower tube is especially important However, the bolt supports the construction speed, the construction difficulty is relatively small, the cost is low and has the discretion, if the seal is not strict, when the anchor is easy to take off, the water mud will come in once the grouting The opening of the open pit can be beneficial to the construction of the soil and the underground chamber. If the seal is too solid, the secondary grouting will exist again Support technique commonly used in deep foundation pit support. In recent years, the bolt technology has obtained a wide variety of slurry to open the sealing problem. In addition, the interval between two grouting should be based on the work Use, also accumulated a lot of design and construction experience. The conditions of the course are determined by the test, the spacing is too short or too long, and the secondary grouting cant be due to the slurry The analysis of the design Angle of the bolt failed. How appropriate is it to design